TOMATECH AUTOMATION
0 0 6 ZM5 ZM4 ZMY ZMZ ZMX
ZMX, ZMZ, ZMY, ZM4, ZM5: Return and initial backlash direction of X, Y, Z axes machine
zeroes
at power on
0: Zero return type C, machine zero return and backlash direction is positive;
1: Zero return type B, machine zero return and backlash direction is negative.
0 0 7 ZC5 ZC4 ZCY ZCZ ZCX
ZCX, ZCZ, ZCY, ZC4, ZC5 =0: Separate DEC and zero signals needed during machine
zero
return
=1: DEC and zero signals together by a proximity switch during
machine zero return
Note: This parameter should be set to 1 if a proximity switch is taken as both deceleration and
zero signal.
0 1 1 *** *** NORF ZNIK *** ***
Bit3 1: Manual machine zero return inactivity
0: Manual machine zero return active
Bit2 1: Stop at zero by pressing direction key once in zero return with direction key locked;
0: Direction key should be held on in zero return with direction key unlocked.
0 1 2 APRS *** *** ISOT
Bit7 1: ABSOLUTE automatically set after reference return, the coordinate set by
parameter
No.049 and No.050;
0: ABSOLUTE not automatically set after reference return
Bit 6 1: Prior to machine zero return after power-on or E-stop, manual rapid traverse active
0: Prior to machine zero return after power-on or E-stop, manual rapid traverse inactive
0 1 4 *** *** *** ZRS5 ZRS4 ZRSY ZRSZ ZRSX
Bit4~0 1: 5th, 4th, Y, Z, X has machine zero, the system detects DEC signal and zero
signal in
executing machine zero return.
404
Volume Ⅲ Connection
0: 5th, 4th, Y, Z, X has no machine zero, the system does not detect DEC signal and zero
signal and directly executes machine zero return
1 8 3 *** *** *** MZR5 MZR4 MZRY MZRZ MZRX
Bit4 1: For the 5th axis, press to execute machine zero return；
0: For the 5th axis, press to execute machine zero return（has not defined the press key
in the standard PLC）
Bit3 1: For the 4th axis, press to execute the machine zero return；
0: For the 4th axis, press to execute the machine zero return.
Bit2 1: For Y axis, press to execute the machine zero return；
0: For Y axis, press to execute the machine zero return.
Bit1 1: For Z axis, press to execute the machine zero return；
To Next Page
Loading...