TOMATECH AUTOMATION
0: For Z axis, press to execute the machine zero return.
Bit0 1: For X axis, press to execute the machine zero return；
0: For X axis, press to execute the machine zero return.
1 8 8 *** RRTn *** *** ***
［Data type］ Bit axis
RRTn 1: when Y, 4th, 5th are rotary axis, the zero return use D mode;
0: when Y, 4th, 5th are rotary axis, the zero return use A, B,C mode( need to power-on
again).
0 3 3 ZRNFLn
［Data type］ Word axis
［Data meaning］ Lowest speed rate of X,Z machine zero return.
［Data unit］
Set unit Data unit
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］
IS-B IS-C
Metric machine 6～4000 6～4000
Inch machine 3～1500 3～1500
0 4 7 PRSn
［Data type］ Word axis
［Data meaning］ Setting value of absolute coordinate after machine zero return is
performed
Chapter 3 Parameters
405
Volume Ⅲ Connection
［Data unit］
Setting unit IS-B IS-C
Metric input 0.001 mm 0.0001 mm
Inch input 0.0001 inch 0.00001 inch
［Data range］ -99999999～99999999
1 1 3 REF_SPDn
［Data meaning］ high-speed of each axis machine zero return.
［Data unit］
Set unit Data unit
Metric machine mm/min
Inch machine 0.1inch/min
［Data range］ 10～99999999
1 1 4 REF_OFFSETn
［Data type］ Word axis
［Data meaning］ Offset value of each axis machine zero point
［Data unit］
Set unit IS-B IS-C
Metric input 0.001 mm 0.0001 mm
To Next Page