TOMATECH TAC-100XT User Manual

TOMATECH AUTOMATION
press , to move the line where the current cursor is.
11.2 Often Used File Operation Function Introduction
11.2.1 File extension and return
1) Move the cursor to the required extension file, press to extend it as follows:
Display the user
parameters, tool
compensation, pitch
compensation, PLC
programs, part
program and so on
in the CNC catalog
window
Display all files
in the U disk
catalog
window
284
Ⅱ Operation
2) Move the cursor to the target file, press to return the previous catalog of the current
file as follow:
11.2.2 File selection and cancellation of file selection
Take an example of U:\TAC-100XT_backup\user\NCPROG\O0010.CNC to introduce the
selection and
cancellation.
1) Press to select setting interface, press to enter the file management
page as follows:
Chapter 13 Communication
285
Ⅱ Operation
2) Move the cursor to O0101.CNC as follows:
3) Press （or ）to select O0101.CNC as follows:
286
Ⅱ Operation
4) Press (or again ) to cancel the selection of O0101.CNC.
11.2.3 File copy
Refer to Section 11.2.2 to select the file. When the cursor is in the U disk catalog window,
is pressed and the the files in the U disk is copied to the CNC; when the cursor is in the
CNC catalog

TOMATECH TAC-100XT Specifications

General

Brand	TOMATECH
Model	TAC-100XT
Category	Control Systems
Language	English