TOMATECH AUTOMATION
cable when
PC and CNC are turned off.
12.2.2 Communication setting baud rate
Setting the baud rate of communication ensures that the baud rate of PC is the same that
of the
CNC communication.
The communication baud of the serial port is set by No.044; click [Communication Setup]
in the
menu [Communication] and the system pops up a dialog box as follows:
Set the serial port and baud rate. The baud rate should be not less than 4800 when the
data is
transmitted between CNC and PC, the factory setting is :115200.
Chapter 13 Communication
297
Ⅱ Operation
Note 1:TAC-1002T has no network function, and so it has no network setting in its
communication.
Note 2: Stop machining when the machining is being done to get the stable communication.
Note 3: Must not turn off during the data transmission, otherwise, it causes the mistaken data
transmission.
298
Ⅱ Operation
CHAPTER 13 MACHINING EXAMPLES
Machine a part by a bar stock with dimension Φ136mm×180 mm, as follows:
4
×
×
×
Z
Fig. 13-1
Machine it with 4 tools as follows:
Tool number Tool shape Explanation
No. 1
Outer circle rough turning tool
No. 2
Outer circle finish turning tool
No. 3
Grooving tool, tool width 3mm
Chapter 14 Machining Example
299
Ⅱ Operation
To Next Page
Loading...
Need help?
General