TOMATECH AUTOMATION
［Data unit］ Line/r
［Data range］ 100～5000
1 1 0 MGR
［Data meaning］ ratio parameter between encoder and spindle gear: spindle gear
quantity.
［Data range］ 1～255
1 1 1 SGR
［Data meaning］ ratio parameter between encoder and spindle gear: spindle gear
quantity.
［Data range］ 1～255
3.2.7 Spindle control
0 0 1 SPIN
Bit4 1: Analog voltage control of spindle speed
0: Switching volume control of spindle speed
K 1 0 RSJG
Chapter 3 Parameters
407
Volume Ⅲ Connection
RSJG 1: when the reset is pressed, CNC does not close M03,M04,M08,M32 output
signal；
0: when the reset is pressed, CNC closes M03, M04, M08, M32 output signal
0 2 1 PSANGNT
［Data meaning］ voltage offset offset value when the analog voltage outputs 10V.
［Data unit］ mV
［Data range］ -2000～2000
0 3 6 SPDLC
［Data meaning］ voltage offset offset value when the analog voltage outputs 10V.
［Data unit］ mV
［Data range］ -1000～1000
0 3 7 GRMAX1
0 3 8 GRMAX2
0 3 9 GRMAX3
0 4 0 GRMAX4
［Data meaning］ GRMAX1, GRMAX2, GRMAX3, GRMAX4: Max. speeds of spindle
gear 1, 2,
3, 4 respectively when analog voltage output is 10V (function defined by
TAC-100XT PLC: if the spindle automatic gearing is active, they are the
speeds of M41, M42, M43, M44; if the automatic gearing is inactive or CNC is
powered on, the gears are memorized by parameter setting or the gear 1 is
defaulted.)
［Data unit］ r/min
［Data range］ 10～9999
0 6 7 SFTREV
［Data meaning］ output voltage in spindle gear shifting.
To Next Page