TOMATECH AUTOMATION
［Data unit］ mV
［Data range］ 0～10000
0 6 8 SJOGREV
［Data meaning］ spindle rotary axis speed in Manual (MPG) mode.
［Data unit］ r/min
［Data range］ 0～3000
0 6 9 PEALMTIM
［Data meaning］ pressure low alarm time width.
［Data unit］ ms
［Data range］ 0～60000
0 7 0 ENCODER_CNT
［Data meaning］ spindle encoder lines.
［Data unit］ line/r
408
Volume Ⅲ Connection
［Data range］ 100～5000
0 7 1 RESET_TIME
［Data meaning］ reset signal output time.
［Data unit］ ms
［Data range］ 16～4080
0 7 2 SAR_DELEY
［Data meaning］ spindle speed arrival signal delay check time.
［Data unit］ ms
［Data range］ 0～4080
0 7 3 SPMOTORMAX
［Data meaning］ max. clamp speed of spindle motor speed.
［Data unit］ r/min
［Data range］ 0～4095
Setting value=（max. clamp speed of spindle motor/its max. speed）×4095.
0 7 4 SPMOTORMIN
［Data meaning］ min. clamp speed of spindle motor speed.
［Data unit］ r/min
［Data range］ 0～4095
Setting value=（min. clamp speed of spindle motor/its min. speed）×4095.
0 7 5 SPSPEEDLIMIT
［Data meaning］ max. spindle speed ［0: not limit speed］.
［Data unit］ r/min
［Data range］ 0～6000
1 0 9 SPL_REV_SPD
［Data meaning］ rotary speed in spindle jog.
Chapter 3 Parameters
409
Volume Ⅲ Connection
To Next Page