TOMATECH AUTOMATION
is executed;
� CUT TIME: the system counts the time when the automatic run is started, time unit is
hour,minute and second in order.
The part counting and cut time are memorized at power-down, the clearing ways for them
are shown below:
Method 1：Ⅱ Operation
Press and the following interface appears:
At the moment, press to clear part count, press to clear the cut time;
Method 2：
Directly press to enter the absolute coordinate page, at the moment, press +
to clear part counting, simultaneously press + to clear the cut time.
2) RELATIVE POS display interface
Displayed U, W coordinates are the current position relative to the relative reference point,
and they are held on when power on. They can be cleared at any time. When No.005
Bit1=1, and the absolute coordinates are set by G50, the relative coordinates are set
simultaneously.Clearing U, W:
Method 1:Ⅱ Operation
Press and the following page appears:
At the moment, press to clear U value, and press to clear W value;
Method 2：
Switch to the relative coordinate page, at the moment, press . Press to clear U
value when the big character “U” flashes in the page. Method of clearing W value is the
same those of clearing U value;
Note: Clearing method is the same when many axes are enabled.
3) INTEGRATED POS display interface
Clearing method of absolute coordinates are shown below:
Method 1：Ⅱ Operation
Press and the following page is shown:
At the moment, press to clear X coordinate value, and press to clear Z coordinate value;
Method 2：
Switch to the integrated coordinate page, simultaneously press + to clear X
machine coordinate value; meanwhile, press + to clear Z machine coordinate value.
Note 1: Clearing method is the same when many axes are enabled.
Note 2: Clearing operation is enabled only when each axis has no machine zero (No.0014 bit0～
bit4 is set to 0) .
4) POS&PRG display interface
In POS&PRG interface, it displays ABSOLUTE, RELATIVE coordinate of the current
position (ABSOLUTE, DIST TO GO of current position and machine coordinates will be
displayed when No.180 BIT0 is set to 1) as well as 7 blocks of current program together.
During the program execution, the displayed blocks are refreshed dynamically and the
cursor is located in the block being executed.
peration
1.3.2 PRG interface
To Next Page
Loading...
Need help?
General