TOMATECH AUTOMATION
Ⅱ Operation
7.5.6 Locking and unlocking the offset value
In order to protect the offset value to be operated by mistaken, the offset values can be
put into
lock, the operation steps are as follows:
1) Move the cursor to the location of the offset number to be locked;
2) Press the key, the current offset value will be backlighted for locking, which is
forbidden to alter, press the key again, the locking may be cancelled. No.1 tool offset
is locked as follows:
Note: The tool wear values can’t be locked.
7.5.7 No.0 tool offset moving workpiece coordinate system
When No.012 Bit 6 is set to 1, No. 0 tool offset moving workpiece coordinate system is
valid.
After the value is input in No. 0 tool offset, the workpiece coordinate system executes the
offset
based on the input value.
Chapter 7 Tool Offset and Setting
255
Ⅱ Operation
Before inputting No.0 tool offset
After inputting No.0 tool offset
As the above figure, after X100, Z100 in No.0 tool offset is input, the workpiece coordinate
system offsets X100, Z100.
Note: When No. 0 offset modification is valid real-time, No. 0 tool offset must be set before the
system runs a
program, otherwise, the run path will offset.
256
Ⅱ Operation
CHAPTER 8 AUTO OPERATION
8.1 Automatic Run
8.1.1 Selection of a program running
Refer to Section 6.3.
8.1.2 Start of automatic run
1. Press to select the Auto mode;
2. Press to start the program, and the program automatically runs.
Note: Since the program execution begins from the block where the cursor locates, before
pressing the
To Next Page
Loading...
Need help?
General