TOMATECH AUTOMATION
FOREWORD
Dear user,
We are really grateful for your patronage and purchase of thisTAC-100XT
Turning CNC system made by TOMATECH AUTOMATION CO.,LTD
The user manual describes the programming, operation, installation and
connection
of thisTAC-100XT Turning CNC system. Please read it carefully before
operation in order to get the safe and effective working.
Warning
This system can only be operated by authorized and qualified personnel as
improper operations may cause accidents.
Please carefully read this user manual before use!
Note: The power supply installed on (in) the cabinet is exclusive to
TOMATECH’S CNC systems.
The power supply form is forbidden to be used for other purposes.
Otherwise, there may be extreme danger!
This user manual shall be kept by final user.
Notes
III
Notes
■ Delivery and storage
� Packing box over 6 layers in pile is unallowed.
� Never climb the packing box, neither stand on it, nor place heavy objects on it.
� Do not move or drag the product by the cables connected with it.
� Forbid collision or scratch to the panel and displayer.
� Packing box should be protected from damping, insolation and raining.
■ Open packing box to check
� Ensure things in packing box are the required ones.
� Ensure the product is not damaged in delivery.
� Ensure the parts in packing box are in accordance to the order.
� Contact us in time if the product type is inconsistent with the order, there is short of
accessories, or product damage in delivery.
■ Connection
� Only qualified persons can connect the system or check the connection.
� The system must be earthed, its resistance must be less than 4 Ω and the ground wire
cannot be replaced by zero wire.
� Connection must be correct and firm to avoid the product to be damaged or other
unexpected result.
� Connect with surge diode in the specified direction to avoid the damage to the system.
� Switch off power supply before pulling out plug or opening electric cabinet.
To Next Page
Loading...
Need help?
General