TOMATECH AUTOMATION
the
level setting function, and its password grade is divided into five, from high to low grade:
2nd grade
(machine manufacturer), 3rd grade (device management), 4th grade (engineer), 5th grade
(machining
268
Ⅱ Operation
operation), 6th grade(operation limit). The current operation grade is displayed in “Current
Level:_” in
the level setting page.
2nd grade：it is for the machine manufacturer, which permits the machine manufacturer to
alter the
state parameters, data parameters, pitch compensation data, tool compensation data, to
edit
programs, to transmit PLC and so on.
3rd grade: it permits to alter state parameters, data parameters, tool compensation data
and to edit
programs.
4th grade: it permits to alter tool compensation data (toolsetting operation), macro
variables, to edit
programs, but not to alter state parameters, data parameters and pitch compensation
data.
5th grade: it permits to alter tool compensation data, not to select and edit programs, and
not to alter
state programs, data programs and pitch compensation data.
6th grade: it has no level to operate only the machine operation panel, not to alter tool
compensation
data, not select and edit programs, not to alter state parameters, data parameter and pitch
compensation data.
1) Operation grade entry
a) Move the cursor to the line “INPUT PASSWORD” in the CNC setting page;
b) Input the operation password(the system displays one “*” as soon as a number is input;
c) Press and the operator can enter the corresponding grade operation;
d) After the operator enters the corresponding operation grade page, the prompt column
prompts the system’s current grade, and the corresponding operations as follows:
Note 1: The defined password length corresponds to the operation grade, and the user cannot
increase
or reduce the length at will, which is shown below:
Operation
grade Length Initial
password
3rd grade 5 digits 12345
4th grade 4 digits 1234
To Next Page
Loading...
Need help?
General