TOMATECH AUTOMATION
Note 1: It is valid when PC5 is connected with 0V, and it is different with other feed axes(it is valid
when PC
of CN11～CN14 axis interface is connected with +24V).
Note 2: They are valid when X5.0～X5.3 are connected with 0V, and they are different with other
input
signals( other are valid when they are connected with +24V).
Note 3: The internal circuit of PC5，X5.0~X5.3 signals are shown below:
Fig. 2-19 PC5, X5.0～X5.3 circuit
CP5+,CP5- Spindle pulse signal
DIR5+,DIR5- Spindle direction signal
ALM5 Spindle alarm signal
RDY5 Spindle ready signal
PC5 Spindle zero signal
SVC-OUT1 Analog voltage output 1
SVC-OUT2 Analog voltage output 2
SET5 Spindle setting signal
EN5 Spindle enabling signal
X5.0~X5.3 PLC address，only LOW is valid
Y5.0~Y5.3 PLC address
Fig. 2-18 CN15 spindle interface（DB25 female）
1：CP5+
2：DIR5+
3：GND
4：ALM5
5：X5.0
6：X5.1
7：RDY5
8：X5.2
9：GND
10：PC5
11：+24V
12：GND
13：SVC-OUT1
14：CP5-
15：DIR5-
16：GND
17：+24V
18：SET5
19：EN5
20：Y5.0
21：Y5.1
22：Y5.2
23：Y5.3
24：SVC-OUT2
To Next Page
Loading...