TOMATECH AUTOMATION
3.26.2 Transfer and cycle............................................................................................ 147
3.27 Metric/Inch Switch............................................................................................... 150
CHAPTER 4 TOOL NOSE RADIUS COMPENSATION (G41, G42) ..........................152
4.1 Application ........................................................................................................... 152
4.1.1 Overview............................................................................................................152
4.1.2 Imaginary tool nose direction ........................................................................... 152
4.1.3 Compensation value setting.............................................................................. 156
4.1.4 Command format ............................................................................................. 157
4.1.5 Compensation direction ................................................................................... 157
4.1.6 Notes ................................................................................................................ 159
4.1.7 Application ........................................................................................................160
4.2 Tool Nose Radius Compensation Offset Path..................................................... 161
4.2.1 Inner and outer side.......................................................................................... 161
4.2.2 Tool traversing when starting tool..................................................................... 162
4.2.3 Tool traversing in Offset mode.......................................................................... 163
4.2.4 Tool traversing in Offset canceling mode ..........................................................167
4.2.5 Tool interference check..................................................................................... 168
4.2.6 Commands for canceling compensation vector temporarily.............................. 170
Ⅱ Operation
CHAPTER 1 OPERATION MODE AND DISPLAY
INTERFACE...................................................................................................................173
1.1 Panel
Division...........................................................................................................................173
1.1.1 State indication ......................................................................................................174
1.1.2 Edit keypad............................................................................................................174
1.1.3 Menu display .........................................................................................................175
1.1.4 Machine panel .......................................................................................................176
1.2 Summary of Operation..............................................................................................179
1.3 Display Interface ......................................................................................................179
1.3.1 POS interface ........................................................................................................179
1.3.2 PRG interface........................................................................................................184
1.3.3 TOOL OFFSET Interface ......................................................................................189
1.3.4 ALARM interface ...................................................................................................193
1.3.5 Setting interface.....................................................................................................194
1.3.6 PARAMETER Interfaces........................................................................................196
1.3.7 Diagnosis Interface................................................................................................198
1.3.8 Graph Interface......................................................................................................199
1.3.9 Ladder Interface ....................................................................................................200
CHAPTER 2 POWER ON/OFF AND PROTECTION.....................................................205
2.1 System Power-on ....................................................................................................205
To Next Page
Loading...