Standards Compliance
4
4.2 European Standards
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 251
A - SW (ON) B - Screw (OFF)
Figure 4.13 EMC Filter Switch Location 6
A - SW (ON) B - Screw (OFF)
Figure 4.14 EMC Filter Switch Location 7
If you lose an EMC filter switch screw, refer to Table 4.8 to find the correct replacement screw and install the new
screws with the correct tightening torque.
NOTICE: Only use the screws specified in this manual. Failure to obey could damage the drive.
Table 4.8 Screw Sizes and Tightening Torques
Model Screw Size
Tightening Torque
N∙m
2004 - 2082, 4002 - 4060 M4 × 20 1.0 - 1.3
2110 - 2211, 4075 - 4168 M4 × 25 1.0 - 1.3
2257 - 2415, 4208 - 4675 M5 × 25 2.0 - 2.5
■ Installing the External EMC Noise Filter
Drive models 2xxxA and 4xxxA must meet conditions in this section to comply with EN 61800-3:2004+A1:2012.
Connect an EMC noise filter to the input side (primary side) that complies with European standards as specified
by Yaskawa. Refer to External EMC Noise Filter Selection on page 254 to select the correct EMC noise filter.
Use this procedure to install an EMC noise filter to make machinery and devices added to the drive comply with
the EMC Directive.
1. Install the drive and EMC noise filter on the same grounded metal plate.
2. Wire the drive and motor.
To Next Page
Loading...
