Parameter List
10
10.10 H: Terminal Functions
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 547
No.
(Hex.)
Name Description
Default
(Range)
Ref.
H1-41
(0B55)
Mbus Reg 15C0h
bit1 Input Func
Sets the MFDI function for bit 1 of MEMOBUS/Modbus register
15C0 (Hex.).
F
(1 - 19F)
866
H1-42
(0B56)
Mbus Reg 15C0h
bit2 Input Func
Sets the MFDI function for bit 2 of MEMOBUS/Modbus register
15C0 (Hex.).
F
(1 - 19F)
866
■ H1-xx: Multi-Function Digital Input Setting Values
Setting Function Description Ref.
0 3-Wire Sequence
Sets the direction of motor rotation for 3-wire sequence.
866
1 LOCAL/REMOTE
Selection
Sets drive control for the keypad (LOCAL) or an external source (REMOTE).
ON : LOCAL
OFF : REMOTE
867
2 External Reference
1/2 Selection
Sets the drive to use Run command source 1/2 or Reference command source 1/2 when
in REMOTE Mode.
ON : b1-15 = [Frequency Reference Selection 2], b1-16 [Run Command Selection 2]
OFF : b1-01 = [Frequency Reference Selection 1], b1-02 [Run Command Selection 1]
868
3 Multi-Step Speed
Reference 1
Uses speed references d1-01 to d1-08 [Multi-Step Speed Reference] to set a multi-step
speed reference.
868
4 Multi-Step Speed
Reference 2
Uses speed references d1-01 to d1-08 [Multi-Step Speed Reference] to set a multi-step
speed reference.
868
5 Multi-Step Speed
Reference 3
Uses speed references d1-01 to d1-08 [Multi-Step Speed Reference] to set a multi-step
speed reference.
868
6 Jog Reference
Selection
Sets the drive to use the JOG Frequency Reference (JOG command) set in d1-17. The
JOG Frequency Reference (JOG command) overrides Frequency References 1 to 16 (d1-
01 to d1-16).
868
7 Accel/Decel Time
Selection 1
Sets the drive to use Acceleration/Deceleration Time 1 [C1-01, C1-02] or Acceleration/
Deceleration Time 2 [C1-03, C1-04].
868
8 Baseblock
Command (N.O.)
Sets the command that stops drive output and coasts the motor to stop when the input is
ON.
ON : Baseblock (drive output stop)
OFF : Normal operation
868
9 Baseblock
Command (N.C.)
Sets the command that stops drive output and coasts the motor to stop when the input
terminal is OFF.
ON : Normal operation
OFF : Baseblock (drive output stop)
869
A Accel/Decel Ramp
Hold
Momentarily pauses motor acceleration and deceleration when the terminal is turned ON,
retains the output frequency that was stored in the drive at the time of the pause, and
restarts motor operation.
869
B Overheat Alarm
(oH2)
Sets the drive to display an oH2 [Drive Overheat Warning] alarm when the input
terminal is ON. The alarm does not have an effect on drive operation.
869
C Analog Terminal
Enable Selection
Sets the command that enables or disables the terminals selected in H3-14 [Analog Input
Terminal Enable Sel].
ON : Input to the terminal selected with H3-14 is enabled
OFF : Input to the terminal selected with H3-14 is disabled
870
To Next Page
Loading...
