Parameter List
10
10.10 H: Terminal Functions
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 559
Setting Function Description Ref.
37 During Frequency
Output
The terminal activates when the drive outputs frequency.
ON : The drive outputs frequency.
OFF : The drive does not output frequency.
906
38 Drive Enabled
This terminal activates when the H1-xx = 6A [Drive Enable] terminal activates.
907
39 Watt Hour Pulse
Output
Outputs the pulse that shows the watt hours.
907
3C LOCAL Control
Selected
The terminal activates when the Run command source or frequency reference source is
LOCAL.
ON : LOCAL
OFF : REMOTE
907
3D During Speed
Search
The terminal activates when the drive is doing speed search.
907
3E PID Feedback Low
The activates when the drive detects FbL [PID Feedback Loss].
907
3F PID Feedback
High
The terminal activates when the drive detects FbH [Excessive PID Feedback].
908
4A During KEB Ride-
Thru
The activates during KEB Ride-Thru.
908
4B During Short
Circuit Braking
The terminal activates during Short Circuit Braking.
Note:
When A1-02 = 8 [Control Method Selection = EZ Vector Control], this function is
available if you use a PM motor.
908
4C During Fast Stop
The terminal activates when the fast stop is in operation.
908
4D oH Pre-Alarm
Reduction Limit
The terminal activates when L8-03 = 4 [Overheat Pre-Alarm Selection = Operate at
Reduced Speed (L8-19)] and oH [Heatsink Overheat] does not clear after the drive
decreases the frequency for 10 cycles.
908
4E Braking Transistor
Fault (rr)
The terminal activates when the internal braking transistor overheats and the drive detects
an rr [Dynamic Braking Transistor Fault] fault.
908
4F Braking Resistor
Overheat (rH)
The terminal activates when the braking resistor overheats and the drive detects an rH
[Braking Resistor Overheat] fault.
908
60 Internal Cooling
Fan Failure
The terminal activates when the drive detects a cooling fan failure in the drive.
909
61 Pole Position
Detection
Complete
The terminal activates when drive receives a Run command and the drive detects the
motor magnetic pole position of the PM motor.
909
62 Modbus Reg 1
Status Satisfied
The terminal activates when the bit specified by H2-08 [Modbus Register 1 Bit Select]
for the MEMOBUS register address set with H2-07 [Modbus Register 1 Address Select]
activates.
909
63 Modbus Reg 2
Status Satisfied
The terminal activates when the bit specified by H2-10 [Modbus Register 2 Bit Select]
for the MEMOBUS register address set with H2-09 [Modbus Register 2 Address Select]
activates.
909
65 Standby Output
The terminal deactivates after the drive stops operating and after the time set with b8-51
[Standby Mode Wait Time].
ON : The Run command turns on and the magnetic contactor on the input side turns on.
OFF : The Run command turns off and the drive stops operating. Then, the magnetic
contactor on the input side turns off after the time set with b8-51 [Standby Mode Wait
Time].
909
To Next Page
Loading...
