Yealink T40G

Phone Provisioning
81
Supported Provisioning Protocols
Yealink IP phones support several transport protocols for provisioning:
 Trivial File Transfer Protocol (TFTP)
 File Transfer Protocol (FTP)
 Hyper Text Transfer Protocol – Secure (HTTPS)
 File Transfer Protocol – Secure (FTPS)
Note
There are two types of FTP methods—active and passive. IP phones are not compatible with active FTP.
You can specify the transport protocol in the provisioning server address, for example, http://xxxxxxx. If
not specified, the TFTP protocol is used.
Topic
Provisioning Protocols Configuration
Provisioning Protocols Configuration
The following table lists the parameter you can use to configure provisioning protocols.
Parameter
static.auto_provision.server.type
<y0000000000xx>.cfg
Description
It configures the protocol the IP phone uses to connect to the provisioning server.
Note: It works only if the protocol type is not defined in the access URL of the
provisioning server configured by the parameter "static.auto_provision.server.url".
Permitted
Values
1-HTTP
2-HTTPS
3-FTP
Other values-TFTP
Default
TFTP
Parameter
static.auto_provision.user_agent_mac.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables the IP phone's MAC address to be included in the User-Agent
header of HTTP/HTTPS transfers via auto provisioning.
Permitted
Values
0-Disabled, the phone’s MAC address is not included in the User-Agent header of
HTTP/HTTPS transfers and communications to the web browser.
1-Enabled
Default
1
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.