Yealink T40G Administrator's Guide

Call Features
301
Default
0
Parameter
account.X.auto_dial_num
[1]
<MAC>.cfg
Description
It configures the number that the IP phone first dials out when a user lifts the handset,
presses the Speakerphone or desired line key or dials out a call using account X.
Note: It works only if “account.X.auto_dial_enable” is set to 1 (Enabled). Line key is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String within 1024 characters
Default
Blank
[1]
X is the account ID. For T54S/T48S/T48G/T46S/T46G/T29G, X=1-16; for T52S/T42G/T42S, X=1-12; for
T41P/T41S/T27P/T27G, X=1-6; for T40P/T40G/T23P/T23G, X=1-3; for T21(P) E2, X=1-2; for T19(P) E2, X=1.
Live Dialpad
Live Dialpad allows IP phones automatically dial out the entered phone number without pressing the
send key after a designated period of time.
Topic
Live Dialpad Configuration
Live Dialpad Configuration
The following table lists the parameters you can use to configure live dialpad.
Parameter
phone_setting.predial_autodial
<y0000000000xx>.cfg
Description
It enables or disables the live dialpad feature.
Permitted
Values
0-Disabled
1-Enabled, the IP phone will automatically dial out the entered phone number on the
pre-dialing screen without pressing a send key.
Default
0
Web UI
Settings->Preference->Live Dialpad
Parameter
phone_setting.inter_digit_time
<y0000000000xx>.cfg
Description
It configures the delay time (in seconds) for the IP phone to automatically dial out the
entered phone number without pressing a send key.
Note: It works only if “phone_setting.predial_autodial” is set to 1 (Enabled).
Permitted
Integer from 1 to 14

Yealink T40G Specifications

General

SIP Accounts	3
Wall Mountable	Yes
Opus Codec	No
Display	2.3 inch 132x64-pixel graphical LCD
Network	Dual-port Gigabit Ethernet
PoE	Yes
Headset Support	Yes, RJ9 port
Power Adapter	Optional
Voice Codecs	G.722, G.711(A/μ), G.729AB, G.726
Local Phonebook	1000 entries