The status of the BLF/BLF list DSS key LED. Enable to
specify the LED color for the BLF/BLF list DSS key, and
specify the duration time (in milliseconds) for the
corresponding status of the BLF/BLF list DSS key. The valid
value of the duration time ranges from 100 to 60000ms.
Can be composed of multiple combination of “color” and
“time”. The status will be stuck in an infinite loop until
triggered by other macros.
Supported colors include (must be lowercase):
r (red)
ri (red; red with incoming mark for T48S/G)
ro (red; red with outgoing mark for T48S/G)
g (green)
gi (green; green with incoming mark for T48S/G)
go (green; green with outgoing mark for T48S/G)
o (off)
&L<label> (Optional.): You have to put the “&L<label>”
last in the command flow.
Example: $LEDg1000o100r300&Lidle$ means an infinite
loop for BLF/BLF list DSS key LED status: glow green for
1000ms, be in the off state for 100ms and then glow red
for 300ms. At the same time, the label of the BLF/BLF list
DSS key is changed to “idle”.
Note: The last “color” can be configured without “time”,
and it means permanently displaying the last color until
triggered by other macros. This macro can be only used
for BLF/BLF list feature. For more information, refer to
BLF/BLF List Key LED Status and Behavior Configuration.
To configure EDK list, EDK prompt, EDK soft keys and custom DSS keys, you have to enable EDK feature.
By default, the EDK feature is disabled.
EDK macros.
To Next Page
Loading...
Need help?
General
