Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
522
Account->Advanced->Session Refresher
[1]
X is the account ID. For T54S/T48S/T48G/T46S/T46G/T29G, X=1-16; for T52S/T42G/T42S, X=1-12; for
T41P/T41S/T27P/T27G, X=1-6; for T40P/T40G/T23P/T23G, X=1-3; for T21(P) E2, X=1-2; for T19(P) E2, X=1.
Reboot in Talking
Reboot in talking feature allows IP phones to reboot during an active call when it receives a reboot
request by action URI.
IP phones do not receive and handle HTTP/HTTPS GET requests by default. To use this feature, you need
to specify the trusted IP address(es) for action URI in advance.
Topic
Reboot in Talking Configuration
Reboot in Talking Configuration
The following table lists the parameters you can use to configure reboot in talking.
features.reboot_in_talk_enable
It enables or disables the phone to reboot during a call when it receives a reboot
request by action URI.
Note: It works only if “features.action_uri_limit_ip” is set to “any” or trusted IP
address(es) and it is not the first time for the IP phone to receive HTTP/HTTPS GET
request from the trusted IP address(es).
Features->General Information->Reboot in Talking
Reserve # in User Name
Reserve # in User Name feature allows IP phones to reserve “#” in user name. When Reserve # in User
Name feature is disabled, “#” will be converted into “%23”. For example, the user registers an account
(user name: 1010#) on the phone, the phone will send 1010%23 instead of 1010# in the REGISTER
message or INVITE message to SIP server.
Example of a SIP REGISTER message:
To Next Page
Loading...
Need help?
General
