Directory
255
Favorites Configuration
The following table lists the parameters you can use to configure the favorites.
local_contact.favorite.enable
It enables or disables the Favorites feature.
0-Disabled
1-Enabled, the phone automatically assigns Speed Dial keys for favorite contacts.
local.dsskey_type_config.mode
It configures which screen to enter by long pressing the line key or ext key.
Note: It works only if “local_contact.favorite.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
0-Enter the line key/ext key configuration screen
1-Enter the Add Contact screen
phone_setting.favorite_sequence_type
It configures the order of Speed Dial (Favorite) keys to be assigned automatically.
Note: It works only if “local_contact.favorite.enable” is set to 1 (Enabled). To assign Ext
key, make sure the expansion module has been connected to the phone in advance. It
is only applicable to T54S/T52S/T48S/T48G/T46S/T46G/T29G/T27P/T27G IP phones.
0 - linekey->exp1 key->…->expN key
1 - exp1 key->…->expN key->linekey
2 - linekey page1->page1 from exp1 to expN->page2 from exp1 to
expN->…->linekey from page2 to page3
3-page1 from exp1 to expN->page2 from exp1 to expN->…->linekey
Note: N is the number of your connected expansion modules.
Lightweight Directory Access Protocol (LDAP)
LDAP is an application protocol for accessing and maintaining information services for the distributed
directory over an IP network. You can configure the IP phones
to interface with a corporate directory
server that supports LDAP version 2 or 3. The following LDAP servers are supported:
Microsoft Active Directory
Sun ONE Directory Server
To Next Page
Loading...
Need help?
General
