Yealink T40G Administrator's Guide

Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
468
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.parked.talking.action = newcall
Note: It works only if “blf.enhanced.parked.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
Parameter
blf.enhanced.parked.idle.action
<y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is idle
and a call is parked against the monitored phone.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.parked.idle.action = newcall
Note: It works only if “blf.enhanced.parked.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Permitted
Values
String
Default
Blank
BLF Key for Intercom Configuration
The BLF key (not include BLF List key) can also be used to initiate an intercom call.
The following table lists the parameters you can use to configure BLF key for Intercom.
Parameter
features.blf.intercom_mode.enable
<y0000000000xx>.cfg
Description
It enables or disables the IP phone to initiate an outgoing intercom call with a
monitored user when pressing the BLF key.
Note: To use this feature, you also need to configure the intercom mode (configured
by the parameter “features.intercom.mode”). It is not applicable to T19(P) E2 IP
phones.
Permitted
Values
0-Disabled
1-Enabled
Default
0

Yealink T40G Specifications

General

SIP Accounts	3
Wall Mountable	Yes
Opus Codec	No
Display	2.3 inch 132x64-pixel graphical LCD
Network	Dual-port Gigabit Ethernet
PoE	Yes
Headset Support	Yes, RJ9 port
Power Adapter	Optional
Voice Codecs	G.722, G.711(A/μ), G.729AB, G.726
Local Phonebook	1000 entries