Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
22
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Advanced (default password: admin) ->Network->CDP->CDP Status
T42G/T42S/T41P/T41S/T40P/T40G/T27P/T27G/T23P/T23G/T21(P) E2/T19(P) E2:
Menu->Settings->Advanced Settings (default password: admin)
->Network->CDP->CDP Status
static.network.cdp.packet_interval
[1]
It configures the interval (in seconds) at which the IP phone sends the CDP (Cisco
Discovery Protocol) request.
Note: It works only if “static.network.cdp.enable” is set to 1 (Enabled).
Network->Advanced->CDP->Packet Interval (1~3600s)
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Advanced (default password: admin) ->Network->CDP->CDP Interval
T42G/T42S/T41P/T41S/T40P/T40G/T27P/T27G/T23P/T23G/T21(P) E2/T19(P) E2:
Menu->Settings->Advanced Settings (default password: admin)
->Network->CDP->CDP Interval
Manual VLAN Configuration
VLAN is disabled on IP phones by default. You can configure VLAN for the Internet port and PC port
manually. Before configuring VLAN on the IP phone, you need to obtain the VLAN ID from your network
administrator.
The following table lists the parameters you can use to configure VLAN manually.
static.network.vlan.internet_port_enable
[1]
It enables or disables the VLAN for the Internet port.
Network->Advanced->VLAN->WAN Port->Active
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Advanced (default password: admin) ->Network->VLAN->WAN Port->VLAN
Status
T42G/T42S/T41P/T41S/T40P/T40G/T27P/T27G/T23P/T23G/T21(P) E2/T19(P) E2: