Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
106
Topic
Transparency Configuration
Transparency Configuration
The following table lists the parameters you can use to adjust transparency.
phone_setting.idle_dsskey_and_title.transparency
It configures the transparency of the DSS key labels and status bar on the idle screen
for the IP phone.
Note: It is also applicable when the DSS key list is unfolded on the T48S/T48G IP
phone. It is only applicable to T54S/T52S/T48S/T48G IP phones.
0%, the DSS key labels and status bar are non-transparent.
20%, 40%, 60%, 80% or 100%
Settings->Preference->Transparency
Menu->Basic->Display->Transparency
Screen Saver
The screen saver will automatically start when the IP phone is idle for the preset waiting time. You can
stop the screen saver at any time by pressing any key or touching the screen. When your phone is idle
again for a preset waiting time, the screen saver starts again.
By default, the phone screen displays a built-in picture when screen saver starts. The following shows that
the built-in screen saver is displaying on T46S/G IP phones:
To Next Page
Loading...
