EasyManuals Logo

Yealink T40G Administrator's Guide

Yealink T40G
622 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #351 background imageLoading...
Page #351 background image
Call Features
331
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T41P/T41S/T40P/T40G/T29G/T27P/T27
G/T19(P) E2 IP phones. It works only if “features.allow_mute” is set to 1 (Enabled).
Permitted
Values
0-The mute feature is automatically deactivated when the active call ends.
1-The mute state is kept until you change the mute state manually or the phone
restarts.
Default
0
Call Forward
You can forward calls from any line on your phone to a contact. There are two ways of forwarding your
calls:
Forward calls in special situations, such as when the phone is busy or there is no answer, or
forwarding all incoming calls to a contact immediately.
You can set the phone not to forward a call coming from authorized numbers.
Manually forward an incoming call to a number.
Topics
Call Forward Settings Configuration
Call Forward Feature Configuration
Call Forward Synchronization for Server-side Configuration
Call Forward Settings Configuration
You can change the following call forward settings:
Enable or disable the call forward feature. If disabled, the users have no permission to configure call
forward on their phone.
Choose a call forward mode. You can configure call forward for all lines or specific lines.
Allow or disallow users to forward an incoming call to an international telephone number (the prefix
is 00).
Enable or disable forward emergency feature and specify forward authorized numbers. These
numbers will not to be forwarded when the call forward feature is enabled. The incoming call will
not be logged in the Forwarded Calls list.
Enable or disable the display of the Diversion header. The Diversion header allows the phone which
receives a forwarded-call to indicate where the call was from.
The following table lists the parameters you can use to change the call forward settings.
Parameter
features.fwd.allow
<y0000000000xx>.cfg
Description
It enables or disables the call forward feature.

Table of Contents

Other manuals for Yealink T40G

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yealink T40G and is the answer not in the manual?

Yealink T40G Specifications

General IconGeneral
SIP Accounts3
Wall MountableYes
Opus CodecNo
Display2.3 inch 132x64-pixel graphical LCD
NetworkDual-port Gigabit Ethernet
PoEYes
Headset SupportYes, RJ9 port
Power AdapterOptional
Voice CodecsG.722, G.711(A/μ), G.729AB, G.726
Local Phonebook1000 entries

Related product manuals