Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
348
The following table lists the parameter you can use to set a conference type.
It configures the conference type for a specific account.
0-Local Conference, conference is set up with other two parties via the IP phone when
“features.conference.local.enable” is set to 1 (Enabled).
2-Network Conference, conference is set up with multiple parties via the server.
Account->Advanced->Conference Type
[1]
X is the account ID. For T54S/T48S/T48G/T46S/T46G/T29G, X=1-16; for T52S/T42G/T42S, X=1-12; for
T41P/T41S/T27P/T27G, X=1-6; for T40P/T40G/T23P/T23G, X=1-3; for T21(P) E2, X=1-2; for T19(P) E2, X=1.
Local Conference Configuration
Local conference requires a host phone to process the audio of all parties. Yealink IP phones support up
to 3 parties (including yourself) in a local conference call.
You can enable or disable the local conference feature, and configure the way to set up a local
conference.
For a local three-way conference, if the conference initiator leaves the conference, all parties are
disconnected and the conference call ends. You can enable Transfer on Conference Hang Up feature, and
allows the other two parties to remain connected when the conference initiator drops the conference call.
The following table lists the parameters you can use to configure local conference.
features.conference.local.enable
It enables or disables the local conference feature for the IP phone.
Note: The CONF key is only applicable to T29G/T27P/T27G IP phones.
0-Disabled, the Conf/Conference soft key will disappear during a call and the CONF
key/conference DSS key will not work. Local conference cannot be set up even though
the value of the parameter “account.X.conf_type” is set to 0 (Local Conference).
1-Enabled, the user can set up a local conference with other two parties. It works only
when the value of the parameter “account.X.conf_type” is set to 0 (Local Conference).
features.conference.with_previous_call.enable
It enables or disables the IP phone to merge two calls into a conference directly by
pressing the Conf/Conference soft key, CONF key or conference DSS key when there
are two calls on the phone.
Note: The CONF key is only applicable to T29G/T27P/T27G IP phones.
0-Disabled, you can select to set up a conference with the held party or a new party
To Next Page
Loading...
Need help?
General
