Phone Network
49
This method is used to read the attributes associated with
one or more CPE parameters.
This method is used to modify attributes associated with
one or more CPE parameters.
This method causes the CPE to reboot.
This method is used to cause the CPE to download a
specified file from the designated location.
File types supported by IP phones are:
Firmware Image
Configuration File
This method is used to cause the CPE to upload a
specified file to the designated location.
File types supported by IP phones are:
Configuration File
Log File
This method is used to request the CPE to schedule a
one-time Inform method call (separate from its periodic
Inform method calls) sometime in the future.
This method resets the CPE to its factory default state.
This method informs the ACS of the completion (either
successful or unsuccessful) of a file transfer initiated by an
earlier Download or Upload method call.
This method is used to add a new instance of an object
defined on the CPE.
This method is used to remove a particular instance of an
object.
TR069 Configuration
The following table lists the parameters you can use to configure TR069.
static.managementserver.enable
It enables or disables the TR069 feature.