Call Features
323
feature on the IP phone.
Example:
account.1.dnd.off_code = *74
Note: It works only if the values of the parameters “features.dnd.allow”,
“features.dnd_mode” and “account.X.dnd.enable” are both set to 1. It is not applicable
to T19(P) E2 IP phones.
String within 32 characters
Features->Forward& DND->DND->AccountX->Off Code
Menu->Features->DND->AccountX->Off Code
[1]
X is the account ID. For T54S/T48S/T48G/T46S/T46G/T29G, X=1-16; for T52S/T42G/T42S, X=1-12; for
T41P/T41S/T27P/T27G, X=1-6; for T40P/T40G/T23P/T23G, X=1-3; for T21(P) E2, X=1-2.
DND Synchronization for Server-side Configuration
DND synchronization feature provides the capability to synchronize the status of the DND features
between the IP phone and the server.
If the DND is activated in phone mode, the DND status changing locally will be synchronized to all
registered accounts on server; but if the DND status of a specific account is changed on server, the DND
status locally will be changed.
The following table lists the parameters you can use to configure DND synchronization for server-side.
features.feature_key_sync.enable
It enables or disables to synchronize the feature status between the IP phone and the
server.
Note: It applies to the DND synchromization and forward synchromization.
0-Disabled
1-Enabled, the IP phone sends a SUBSCRIBE message with event “as-feature-event”.
features.dnd.feature_key_sync.enable
It enables or disables the DND feature synchronization.
Note: It works only if “features.feature_key_sync.enable” is set to 1 (Enabled).
0-Disabled
1-Enabled, server-based DND is enabled. Server and local phone DND are
synchronized.
To Next Page
Loading...
Need help?
General
