Advanced Features
475
Topics
State Indicator of Intercom Contact
State Monitor for Intercom Contact Configuration
State Indicator of Intercom Contact
The following table shows the LED indicator associated with the Intercom key:
The monitored user is idle.
Fast-flashing red (200ms)
The monitored user receives an incoming call.
The monitored user is dialing.
The monitored user is talking.
The monitored user does not exist.
State Monitor for Intercom Contact Configuration
The following table lists the parameters you can use to configure state monitor for intercom contact.
features.intercom.led.enable
It enables or disables the IP phone to display different intercom DSS key LED
status/icons when the status of monitored user changes.
Note: It works only if “features.intercom.subscribe.enable” is set to 1 (Enabled). It is
not applicable to T19(P) E2 IP phones.
features.intercom.subscribe.enable
It enables or disables intercom subscription for the IP phone.
Note: It is not applicable to T19(P) E2 IP phones.
Outgoing Intercom Configuration
Yealink IP phones support two methods for initialing intercom calls.
The following table lists the parameters you can use to configure outgoing intercom.
To Next Page
Loading...
Need help?
General
