Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
278
dialplan.replace.prefix.X
[1]
It configures the entered number to be replaced.
Example:
dialplan.replace.prefix.1 =1
Note: It works only if the values of the parameters “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
String within 32 characters
Settings->Dial Plan->Replace Rule->Prefix
dialplan.replace.replace.X
[1]
It configures the alternate number to replace the entered number.
Example:
dialplan.replace.prefix.1 = 1 and dialplan.replace.replace.1 = 254245
When you enter the number ”1” and press the send key, the number “254245” will
replace the entered number “1”.
Note: It works only if the values of the parameters “dialplan.digitmap.enable” and
“account.X.dialplan.digitmap.enable” are set to 0 (Disabled).
String within 32 characters
Settings->Dial Plan->Replace Rule->Replace
dialplan.replace.line_id.X
[1]
It configures the desired line to apply the replace rule. The digit 0 stands for all lines. If
it is left blank, the replace rule will apply to all lines on the IP phone.
Note: Multiple line IDs are separated by commas. It works only if the values of the
parameters “dialplan.digitmap.enable” and “account.X.dialplan.digitmap.enable” are
set to 0 (Disabled). It is not applicable to T19(P) E2 IP phones.
0 to 16 (for T54S/T48S/T48G/T46S/T46G/T29G)
0 to 12 (for T52S/T42G/T42S)
0 to 6 (for T41P/T41S/T27P/T27G)
0 to 3 (for T40P/T40G/T23P/T23G)
0 to 2 (for T21(P) E2)
Settings->Dial Plan->Replace Rule->Account
To Next Page
Loading...
Need help?
General
