Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
288
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.apply_to.directory_dial” takes precedence
over that configured by this parameter.
dialplan.digitmap.apply_to.history_dial
It enables or disables the digit map to be applied to the numbers (received calls or
missed calls) dialed from call log lists.
Note: It works only if “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.apply_to.history_dial” takes precedence over
that configured by this parameter.
dialplan.digitmap.apply_to.forward
It enables or disables the digit map to be applied to the numbers that you want to
forward to when performing call forward.
Note: It works only if “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.apply_to.forward” takes precedence over that
configured by this parameter.
0-Disabled
1-Enabled, the incoming calls will be forwarded to a desired destination number
according to the string of the digit map.
dialplan.digitmap.apply_to.press_send
It enables or disables the entered number to match the predefined string of the digit
map after pressing a send key. It is only applicable to the off-hook dialing.
The off-hook dialing includes: pick up the handset, press the Speakerphone key or
press the line key when the phone is idle.
Note: It works only if “dialplan.digitmap.enable” or
“account.X.dialplan.digitmap.enable” is set to 1 (Enabled). The value configured by the
parameter “account.X.dialplan.digitmap.apply_to.press_send” takes precedence over
that configured by this parameter.
To Next Page
Loading...
Need help?
General
