Custom, Australia, Austria, Brazil, Belgium, Chile, China, Czech, Czech ETSI, Denmark,
Finland, France, Germany, Great Britain, Greece, Hungary, Lithuania, India, Italy, Japan,
Mexico, New Zealand, Netherlands, Norway, Portugal, Spain, Switzerland, Sweden,
Russia, United States
It customizes the dial tone.
tone list = element[,element] [,element]…
Where
element = [!]Freq1[+Freq2][+Freq3][+Freq4] /Duration
Freq: the frequency of the tone (ranges from 200 to 4000 Hz). If it is set to 0 Hz, it
means the tone is not played.
For T40P/T40G/T23P/T23G/T21(P) E2/T19(P) E2:
A tone is comprised of at most two different frequencies.
For
T54S/T52S/T48S/T48G/T46S/T46G/T42G/T42S/T41P/T41S/T29G/T27P/T27G:
A tone is comprised of at most four different frequencies.
Duration: the duration (in milliseconds) of the dial tone, ranges from 0 to 30000ms.
You can configure at most eight different tones for one condition, and separate them
by commas. (for example, 250/200,0/1000,200+300/500,200+500+800+1500/1000).
If you want the IP phone to play tones once, add an exclamation mark “!” before tones
(for example, !250/200,0/1000, 200+300/500,200+500+800+1500/1000).
Note: It works only if “voice.tone.country” is set to Custom.
0-Disabled
1-Enabled. If there is an active account, the IP phone will play the default dial tone. If
there is no active account, the IP phone will play the dial tone configured by
“voice.tone.dial”.