Advanced Features
455
Note: It works only if “features.pickup.blf_audio_enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
Ring1.wav, Ring2.wav, Ring3.wav, Ring4.wav, Ring5.wav, Ring6.wav, Ring7.wav,
Ring8.wav, Silent.wav, Splash.wav or custom ring tone name (for example,
Config:Customring.wav).
Features->Pickup & Park->Ring Type for BLF Pickup
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Basic->Sound->BLF Ring Type
T42G/T42S/T41P/T41S/T40P/T40G/T27P/T27G/T23P/T23G/T21(P) E2:
Menu->Settings->Basic Settings->Sound->BLF Ring Type
features.pickup_display.method
It configures the display method of the call party information on the visual prompt.
Note: It works only is “features.pickup.blf_visual_enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
0-Name
1-Number
2-Name Number
3-Number Name
features.blf_pickup_only_send_code
It enables or disables the phone to only dial out feature access code of directed pick
up when preforming BLF/BLF list pickup.
Note: It is not applicable to T19(P) E2 IP phones.
0-Disabled, the phone will dial out feature access code of directed pick up plus
monitored number when performing BLF/BLF list pickup.
1-Enabled, the phone will only dial out feature access code of directed pick up when
preforming BLF pickup.
Example: Configuring Visual and Audio Alert for Monitor Lines
The following example shows configuration for visual and audio for a monitor line.
linekey.1.pickup_value = *97
To Next Page
Loading...
Need help?
General
