Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
462
It configures the custom BLF/BLF List DSS key LED status/icon colors when the
monitored user is ringing.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callin.led = $LEDg1000o$
For
T54S/T52S/T46G/T46S/T42G/T42S/T41P/T41S/T40P/T40G/T29G/T27P/T27G/T23P/T23
G/T21(P) E2 IP phones, the BLF/BLF List DSS key LED glows green for 1000ms and then
goes out.
For T48G/T48S IP phones, the BLF/BLF List DSS key field displays a green icon for
1000ms and then turns to white.
Note: It works only if “blf.enhanced.callin.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
blf.enhanced.callin.callin.action
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor and
monitored user are ringing.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callin.callin.action = newcall
Note: It works only if “blf.enhanced.callin.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
blf.enhanced.callin.talking.action
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is
talking and monitored user is ringing.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.callin.talking.action = newcall
Note: It works only if “blf.enhanced.callin.enable” is set to 1 (Enabled). It is not
applicable to T19(P) E2 IP phones.
To Next Page
Loading...
Need help?
General
