Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series IP Phones
32
or
Menu->Settings->Basic Settings->Wi-Fi->Wi-Fi (On)->Known
Network->Option->Edit->User Name
static.wifi.X.eap_password
[2]
It configures the EAP authentication password of the wireless network X.
Note: It works only if “static.wifi.enable” is set to 1 (Enabled) and
“static.wifi.X.security_mode” is set to WPA-EAP or WPA2-EAP. It is only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T42S/T41S/T29G/T27G IP phones.
String within 64 characters
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Basic->Wi-Fi->Wi-Fi (On)->Known Network (press Add) ->WPA Shared Key
or
Menu->Basic->Wi-Fi->Wi-Fi (On)->Known Network->Option->Edit->WPA Shared
Key
T42S/T41S/T27G:
Menu->Settings->Basic Settings->Wi-Fi->Wi-Fi (On)->Known Network (press Add)
->WPA Shared Key
or
Menu->Settings->Basic Settings->Wi-Fi->Wi-Fi (On)->Known
Network->Option->Edit->WPA Shared Key
static.wifi.show_scan_prompt
It enables or disables the IP phone to prompt you whether to scan Wi-Fi or not after
connecting Wi-Fi USB dongle WF40 to the IP phone.
Note: It is only applicable to
T54S/T52S/T48S/T48G/T46S/T46G/T42S/T41S/T29G/T27G IP phones.
0-Disabled, the IP phone will enable the Wi-Fi feature and try to connect to the known
wireless network (according to the priority) automatically. But if the IP phone fails to
connect to any known wireless network, the IP phone will still display the Wi-Fi
scanning prompt when connecting WF40 to the IP phone.
1-Enabled
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.
[2]
X is Wi-Fi ID. X=1-5.
To Next Page
Loading...
Need help?
General
