185
Corrective Maintenance
Printhead Cables
8/9/07 ZM400/ZM600 Maintenance Manual 14207L-001 A
16. Install the cable around all three printhead cables at the location shown in Figure 62. Be
sure to clip off the excess cable tie.
17. See Figure 52 on page 174 lift the power supply shield back into place.
18. Replace the mounting screw and standoff.
19. See Figure 50 on page 172 and replace the wireless board.
20. See Figure 49 on page 171 and replace the radio card.
21. Did you remove a cutter assembly?
If… Then…
No Go to Reinstall the Electronics Cover on page 187.
Yes Go to Reinstall the Cutter Assembly on page 187.
To Next Page
Loading...