Corrective Maintenance
Printhead Conversion
298
14207L-001 A ZM400/ZM600 Maintenance Manual 8/9/07
7. Clean the printhead with the Zebra Preventative Maintenance kit.
8. See Figure 158 on page 293. Rotate the two printhead pressure dials to the desired
position for your daily printing.
9. Did you remove a cutter assembly?
10.
11.
Reconnect the AC power cord and data cables
12. Turn on (l) the printer.
If… Then…
No Continue with step 10.
Yes Got to Reinstall the Cutter Assembly on page 300.
Caution • When you are loading media or ribbon, remove all jewelry that could come
into contact with the printhead or other printer parts.
Reinstall the media and ribbon.
To Next Page
Loading...