Corrective Maintenance
Ribbon Supply Spindle
312
14207L-001 A ZM400/ZM600 Maintenance Manual 8/9/07
2. Which model of printer do you have?
3. See Figure 176. Place a small amount of grease on the tolerance rings of the ribbon supply
spindle shaft.
Figure 176 • Lubrication
4. See Figure 174 on page 311. Slide the remove tool onto the new spindle assembly, then
gently push the ribbon supply spindle assembly into the printer main frame.
If you have a… Then…
ZM400 a. Push the RSS into the main frame.
b. Go to step 9 on page 313.
ZM600 Continue to the next step.
Important • In step 4, do not use force or pound on the ribbon supply spindle or the
remove tool.
Put grease here.
To Next Page
Loading...