6241A/6242 DC Voltage Current Source/Monitor Operation Manual
Alphabetical Index
I-3
[S]
Safety Precautions ................................... 8-2, 8-14
Sample .................................................... 4-10
Sample Cnt .............................................. 4-6
Save Data ................................................ 4-10
Saving and Loading Parameters ............. 2-48
Saving parameters ................................... 2-48
Scaling SW ............................................. 4-10
SCL Val_A ............................................. 4-11
SCL Val_B .............................................. 4-11
SCL Val_C .............................................. 4-11
Screen Display (Annotations) ................. 2-8
Selecting the Interface ............................ 6-1
Self Test .................................................. 4-14
Set Time .................................................. 9-17
Setting Limiter Value .............................. 2-21
Setting Source Value using
Direct Input Mode ................................... 2-19
Setting the source value .......................... 2-13
Setting the Source Value Using the Cursor
Keys/Rotary Knob
(when the FIT Indicator OFF) ................ 2-14
Setting the Source Value Using the Cursor
Keys/Rotary Knob
(when the FIT Indicator ON) .................. 2-18
SHIFT/LOCAL (Shift Mode/Local) ....... 4-16
Sig Width ................................................ 4-12
SOURCE ................................................. 4-4
Source and Measurement ........................ 9-1
Source and Measurement Function ......... 9-16
Source Function ...................................... 5-22
Source Mode ........................................... 4-15
SOURCE RANGE Section ..................... 2-4
SOURCE Section .................................... 2-3
Source Timing and Measurement Timing 5-41
SPECIFICATIONS ................................. 9-1
Src Delay ................................................. 4-7
Start Value .............................................. 4-6
Status Register Structure ......................... 6-5, 6-10
STBY Key (Output Standby) .................. 4-17
Step Value ............................................... 4-6
Step1 Val ................................................. 4-7
Step2 Val ................................................. 4-7
Stop Value ............................................... 4-6
Store Mode .............................................. 4-9
Supplied Accessories .............................. 1-2
Suspend V ............................................... 4-4
Suspend Z ............................................... 4-4
SWEEP ................................................... 4-5
Sweep Adr ............................................... 4-7
Sweep Measurement ............................... 2-43
Sweep Source Mode Operation .............. 5-12
Sweep Type ............................................. 4-5
SWEEP VAL .......................................... 4-5
SWP Range ............................................. 4-5
SYSTEM ................................................. 4-14
[T]
Talk Only ................................................ 4-14
TECHNICAL REFERENCES ................ 5-1
TER? Command ..................................... 6-40
Test Methods ........................................... 7-1, 7-3
The difference of the Cycle-parameters
in the Pulse Source Mode and the Sweep
Source Mode ........................................... 5-69
TIME ....................................................... 4-7
Total ........................................................ 4-10
TRIG/SWP STOP (Trigger/Sweep Stop) 4-17
TRIGGER Section .................................. 2-5
Two Slope Linear Sweep ........................ 5-19
[U]
UP Key (Increasing the Source Range) .. 4-17
USB ......................................................... 6-8
USB Id .................................................... 4-13
USB Setup ............................................... 6-8
USB Specifications ................................. 6-8
Using an Interface ................................... 6-1
[V]
View Mx/Mn ........................................... 4-10
VS/IS Key (Source Function) ................. 4-18
[W]
Warm-up Time ........................................ 1-13
When Problems Occur ............................ A-1
To Next Page
Loading...
General