Agilent Technologies 7500 ICP-MS - Page 11

Agilent 7500 ICP-MS ChemStation Operator’s Manual
Contents
C-5
Setting Method Filename 5-4
Selecting a Sample 5-6
Editing Element Information 5-7
Editing Report Information 5-10
Checking the Set Method 5-11
Using the Default Method as a Template 5-12
Editing the Default Method 5-13
Entering the Method Information 5-14
Creating/Editing Interference Correction Equations 5-16
Setting the Acquisition Mode 5-19
Setting Acquisition Parameters 5-20
Spectrum 5-20
Setting Parameters for Qualitative Analysis 5-21
Setting Parameters for Semiquantitative Analysis 5-24
Setting Parameters for Quantitative Analysis 5-25
Prevention of EM deterioration 5-35
Time Resolved Analysis (TRA) 5-36
Setting Parameters for Time Resolved Analysis 5-38
Time Program 5-41
Setting Parameters for Time Program 5-43
Isotope Analysis 5-46
Setting Parameters for Isotope Analysis 5-47
Spectrum Multi Tune 5-48
Setting Spectrum [Multi Tune] Acquisition Parameters 5-50
Setup 5-53
Making the Method 5-55
Isotope Analysis [Multi Tune] 5-63
Setting Parameters for Isotope Analysis [Multi Tune] 5-64
Setting the Peristaltic Pump Program 5-65
Setting Corrections for the Method 5-70
Selecting Reports 5-72
Selecting the Edit Analysis Parameters 5-85