Agilent Technologies 7500 ICP-MS

5-4
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Creating a Method
Setting Method Filename
Set the name of a method file by the following procedure.
1 Select Methods>>Run Wizard….
The method wizard starts up. The list view appears on the left and the General Items page
appears on the right.
General Items Page
The list view shows the five page names that make up the method wizard. Click on a
page name, and the page appears, allowing setting of the items required for the
creation of a method. The square  to the left of each page name indicates whether
the items on the page have been set. Upon completion of setting on the page, the
square is shown in green. When the page is on screen and setting is underway, the
square is shown in yellow. When setting hasn’t been yet performed, the square is
shown in red.
NOTE The method wizard can also be run by clicking on the Method Wizard icon.
Method Wizard Icon