Agilent Technologies 7500 ICP-MS

5-5
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Creating a Method
2 Enter a method name and check the method path and system configuration.
Enter a method name using up to 8 characters in the Method Name field. Add the
extension .m. If the extension is not added, it will be automatically added to the
filename. If the same filename exists in Method Path, the existing file will be
replaced by the new file. Method Path shows a location for the method to be saved.
To change it, enter another location.
System Configuration shows the current system configuration. Be sure to set the
system configuration in which you will use the method, as the method wizard
creates a method based on the current system configuration. To change the settings,
click on Cancel to exit ChemStation, and set the system configuration using
ICP-MS Configuration.
3 Click on Next.
The Sample page appears.