Agilent Technologies 7500 ICP-MS User Manual

19-2
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Installing the Agilent 7500 ChemStation Software (Windows 2000)
Installing the Agilent 7500
ChemStation Software (Windows 2000)
This section explains how to set up the computer and install the ChemStation
software G1834B(Rev. B.01.04 or later) for Windows 2000.
WARNING Many computers have voltage selection switches, check for the correct
setting according to your local supply before inserting the power cord.
NOTE Confirm the instrument is in shutdown mode before installing ChemStation. If
instrument is in standby mode, Put the instrument into Shutdown mode via the
ChemStation before installing ChemStation because it is necessary to turn the
instrument power on to download the firmware after installing the ChemStation.
CAUTION The setup procedure in this section is a typical example. The procedure depends on
the computer and printer.
Windows 2000 Configuration
NOTE If the O/S is Windows NT / 2000 selectable install Windows 2000.
NOTE The partition for the ChemStation should be NTFS format.

Agilent Technologies 7500 ICP-MS Specifications

General

Brand	Agilent Technologies
Model	7500 ICP-MS
Category	Laboratory Equipment
Language	English