6-14
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Setting Up a Sequence
Simulating a Sequence
You can check a sequence before running it by “simulating” the sequence. The
simulate sequence command runs through the sequence to check for duplications in
file names, incorrect directory destinations, and to check whether there is enough
disk space available to store your data. The information is contained in a sequence
log file. This section explains how to load and simulate a sequence and how to view
the sequence log.
Simulating a Sequence
A sequence must be loaded before you can simulate it. To load and simulate a
sequence, complete the following steps:
1 Select Sequence>>Load.
The Load Sequence dialog box appears.
Load Sequence Dialog Box
To Next Page
Loading...
