6-15
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Setting Up a Sequence
2 Select a file using one of the following methods:
• Click a file name in the displayed list and click OK.
• Double-click a file name in the displayed list.
• Type the Name and click OK.
The sequence is loaded.
3 Select Sequence>>Simulate Sequence.
The Start Sequence dialog box appears.
Start Sequence Dialog Box
4 Select Full Method as the Method Sections To Run.
This must be checked so that the simulation checks for free disk space.
5 Complete the dialog box.
Refer to “Running a Sequence” in Chapter 8.
6Click Run Sequence.
A status box appears. The top section of the status box indicates how much disk
space is needed for the sequence and how much is available. When the Overwrite
Existing Data Files check box is not checked, the simulation checks whether the
same data file exist or not. When ChemStation completes this simulation, a box
appears to indicate that the sequence verification is done.
To Next Page
Loading...
