Agilent Technologies 7500 ICP-MS - Copying a Tune Parameters

4-98
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Tuning
Copying a Tune Parameters
You can use the Copy Tune Parameter dialog box to copy the tune parameters
from the current file to another tune file or from another tune file to current setting.
To copy the tune parameters, complete the following steps:
1 Select File>>Copy Tune Parameters.
The Copy Tune Parameters dialog box appears.
Copy Tune Parameters Dialog Box
2 Set the parameters as follows:
1) In the Procedure section, select the direction of copy and select the file where
to copy to or where to copy from.
2) In the Copied Parameters section, select the parameters you want to copy.
3Click Copy to copy the parameters.
4 After coping, click Close.