Agilent Technologies 7500 ICP-MS - Selecting the Edit Analysis Parameters

5-85
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Creating a Method
You can click one or more of the following boxes:
• Screen
Generates the report and displays it on the ChemStation screen.
• Printer
Generates the report and sends it to the ChemStation printer.
• File
Generates the report and saves it as a file. Use the dialog box to give this file a
name.
For more information about the Isotope Dilution Analysis report, refer to Chapter
15, “Generating an Isotope Dilution Analysis Report”
After setting all selected report options, the screen goes on to Edit Analysis
Parameters, explained later in this chapter.
Selecting the Edit Analysis Parameters
After you set the report options, the ChemStation enables you to edit the analysis
parameters for FullQuant, SemiQuant, Isotope Ratio (IR) and Isotope Dilution (ID).
Please select the items you want to edit and click OK.
Edit Analysis Parameters Dialog Box
If you select FullQuant and click OK, the Edit Calibration Parameters dialog box
appears, followed by the Blank Conc. Subtraction (FullQuant) dialog box.