5-94
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Creating a Method
Modifying the Method Information
If you do not want to change the method parameters, but want to add comments
about the method or change the conditions for running and saving the method, you
can edit the method information section of the method separately. To do so,
complete the following steps:
1 Select Top
>>Methods.
The Methods menu appears.
2 Select Methods
>>Edit Method Information.
The Method Information dialog box appears. For more information about this
dialog box, see “Entering the Method Information” in this chapter.
3 Make the changes you want and click OK.
The dialog box disappears, but changes are not recorded to the method until you
save the method.
4 To save the method, select Methods
>>Save.
The Method Save Options dialog box appears. Save the method as described in
Saving a Method and Calibration earlier in this chapter.
NOTE You can also modify this section of a method by selecting Method>>Edit Entire
Method. Click only the Method Information box in the Edit Entire Method dialog
box, and click OK. When the Method Information dialog box appears, make the
changes you want and click OK. Then, complete the saving steps as described in
Saving a Method and Calibration earlier in this chapter.
To Next Page
Loading...
