11-3
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Creating Custom Reports/Database
Creating a Custom Report
You can use ChemStation’s Custom Report feature to create reports that includes
only the information needed. Create a report template for each method you use. This
section explains how to create a Custom Report and how to save the report as a
template.
If you are creating a quantitative report template, you must check the method to
ensure that the calibration curves are created for that method. For information about
creating calibration curves, see Chapter 12, “Performing a Quantitative Analysis”.
NOTE The procedures in this section assume that you are creating a quantitative custom
report. If you are creating a semiquantitative custom report, select the appropriate
item from the SemiQuant menu in Data Analysis.
Creating a Custom Report Template
To create a template, complete the following steps:
1 Select Data Analysis>>Main Panel.
The Data Analysis window appears.
To Next Page
Loading...
Need help?
General
