Agilent Technologies 7500 ICP-MS

18-2
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Installing the Agilent 7500 ChemStation Software (Windows XP)
Installing the Agilent 7500
ChemStation Software (Windows XP)
This section explains how to set up the computer and install the ChemStation
software G1834B (Rev. B.02.00 or later) for Windows XP.
WARNING Many computers have voltage selection switches, check for the correct
setting according to your local supply before inserting the power cord.
NOTE Confirm the instrument is in shutdown mode before installing ChemStation. If
instrument is in standby mode, Put the instrument into Shutdown mode via the
ChemStation before installing ChemStation because it is necessary to turn the
instrument power on to download the firmware after installing the ChemStation.
CAUTION The setup procedure in this section is a typical example. The procedure depends on
the computer and printer.
Windows XP Configuration
NOTE If the O/S is Windows 2000 / XP selectable install Windows XP.
NOTE The partition for the ChemStation should be NTFS format.