P-3
Agilent 7500 ICP-MS ChemStation Operator’s Manual
Preface
Chapter 5, “Creating a Method”, explains how to create a method for data
acquisition.
Chapter 6, “Setting Up a Sequence”, explains how to arrange samples when
analyzing samples automatically.
Chapter 7, “Chained Sequence”, explains how to edit and use chained sequence.
Chapter 8, “Running a Sample Analysis”, explains how to analyze an unknown
sample.
Chapter 9, “Viewing Spectra”, explains how to interpret the spectra from an
unknown sample to determine what elements are present in the sample.
Chapter 10, “Viewing a Time Chart”, explains how to analyze the results from an
unknown sample acquired using time resolved or time program mode to determine
what elements are present in the sample.
Chapter 11, “Creating Custom Reports Database”, describes how to create a
template to use for generating custom reports and how to set up databases using the
results of quantitative and semiquantitative analysis.
Chapter 12, “Performing a Quantitative Analysis”, explains how to determine
concentrations of elements in unknown samples by comparing with calibration
curves.
Chapter 13, “Performing a Semiquantitative Analysis”, explains how to
determine concentrations of all elements based on a previously stored element
response file.
Chapter 14, “Performing an Isotope Ratio Analysis”, explains how to measure
and quantitate isotope ratios.
Chapter 15, “Performing an Isotope Dilution Analysis”, explains how to
determine the concentration of elements using an isotope dilution technique.
Chapter 16, “Tools Menu”, explains how to generate multiple types of reports for
multiple data files continuously using DoList.
Chapter 17, “Database Editor”, explains how to edit the ICP-MS databases which
are supplied with the ChemStation.
Chapter 18, “Installing the Agilent 7500 ChemStation Software (Windows
XP)”, explains how to set up the computer and install the ChemStation software.
To Next Page
Loading...
Need help?
General
